DWT-B03R Micro bodypack transmitter
Discontinued
This third generation DWX bodypack transmitter has been designed for use in theatres, broadcast, and studio based TV production, where lightweight and compact devices are preferred. The magnesium manufactured casing is rain, sweat and spray proof to IPX4/IPX5 ratings. When used with the DWR-R03D, this transmitter has a 148MHz wideband spectrum that is split into two segments; (Low) 470.025MHz to 614MHz, and (High) 566.025MHz to 714MHz. Both low and high bands have step increments of 25kHz.
With dimensions of 53 x 60 x 17mm the DWT-B03R is 27% smaller than the DWT-B01N beltpack transmitter. Power is via a single rechargeable Sony NP-BX1 lithium-ion battery, which gives up to 7-hours operation. The battery can be charged directly or remaining inside the DWT-B03R with the BC-DWX1 dual charger. Microphone input is via ‘small 3-pin’ locking connector making it compatible with the ECM77LM lavalier microphone amongst others. The front facing panel has an OLED screen for easy viewing of settings, along with power, set and navigation buttons. The side panel of the unit houses the removable antenna and 3-pin microphone input.
Included accessories: Belt clip, NP-BX1 Li-ion battery, carrying case, scribble sheet, and CD-ROM.
When used with DWR-R03D, codec modes offer the following specifications:
Encryption: AES256bit. Wireless interface: WiDIF-HP. Oscillator type: Crystal-controlled PLL synthesizer. RF power: 2/10/25mW. Maximum input level: -22dBu, mic; +24dBu, line. Audio attenuation range: 0-48dB, in 3-dB steps, MIC input mode only. Frequency response: 20Hz to 22kHz. Dimensions (W x H x D): 53 x 60 x 17mm, excluding antenna. Weight: 99g, including batteries.
DWT-B30 Beltpack transmitter
DWT-B30L and DWT-B30/H (low band and high band) has the same feature set as DWT-B03R however it is housed in a larger format case. The casing used has the same dimensions as the older DWT-B01N.
RF power: 2/10/25mW. Maximum input level: -22dBu, mic; +24dBu, line. Audio attenuation range: 0-48dB, in 3-dB steps, MIC input mode only. Frequency response: 20Hz to 22kHz. Dimensions (W x H x D): 63 x 17 x 73mm. Weight: 125g, including batteries.
DWM-02N Handheld transmitter
This body only, handheld microphone transmitter is compatible with Sony 31.3mm/pitch 1.0mm threaded interchangeable capsules including the CU-C31 cardioid condenser capsule, the CU-F31 super cardioid dynamic capsule, and the CU-F32 wide cardioid dynamic capsule. The output power is user selectable with options of 1/10/50mW with the lowest offering better battery life of up to 5-hours, using two alkaline AA battery cells. The power switch, OLED display, navigation/selection buttons, and battery compartment is accessed by unscrewing the threaded grip of the microphone body. The battery can be recharged using the optional BC-DWX1 battery charger dock.
Included accessories: Identification ring set, microphone holder, USB adapter cable, carrying case, stand adaptor, PF1/2 to W3.8 type adaptor, and CD-ROM.
Wireless interface: WiDIF-HP. Oscillator type: Crystal-controlled PLL synthesizer. RF power: 1/10/50mW. Maximum input level: -16dBu, with 0dB attenuation. Audio attenuation range: 0-21dB, in 3-dB steps. Frequency response: 20Hz to 22kHz. Dimensions (diameter x L): 37.1 x 194mm. Weight: 235g, including batteries.
DWT-P01N Plug-on transmitter
Discontinued
This unit has the functionality of the DWT-B01N however it has a female 3-pin XLR for connecting standard vocal microphones such as the Sony F-112 interview mic. 48V phantom power is switchable for microphones with the powering requirement.
Included accessories: Soft case, spare battery case, USB adapter cable, and CD-ROM.
Oscillator type: Crystal-controlled PLL synthesizer. RF power: 1/10/50mW. Maximum input level: -22dBu, mic; +24dBu, line. Audio attenuation range: 0-48dB, in 3-dB steps, MIC input mode only. Dimensions (W x H x D): 44 x 78 x 44mm. Weight: 245g, including batteries.