UK Sales: 0191 418 1122         International: +44 191 418 1133

Menu

www.canford.co.uk

19 February 2025

FOCUSRITE REDNET HD32R AUDIO INTERFACE Rackmount, 32x32 Pro Tools HD I/O, Dante I/O, dual PSU

Stock code
95-8414
Brand
Focusrite
Model number
  • REDNET HD32R
FOCUSRITE REDNET HD32R AUDIO INTERFACE Rackmount, 32x32 Pro Tools HD I/O, Dante I/O, dual PSU
FOCUSRITE REDNET HD32R AUDIO INTERFACE Rackmount, 32x32 Pro Tools HD I/O, Dante I/O, dual PSUFOCUSRITE REDNET HD32R AUDIO INTERFACE Rackmount, 32x32 Pro Tools HD I/O, Dante I/O, dual PSU

FOCUSRITE AUDIO INTERFACES - AoIP

Built on Focusrite’s decades of interface design experience and attention to audio detail, the RedNet series of audio interface has been designed for post production, broadcast audio, live sound and recording studio environments. These interfaces run with the flexibility of Dante, with some offering dual network connections and power redundancy.

RedNet A16R MKII Rackmount, 16x16 analogue I/O

RedNet D16R MKII Rackmount, 16x16 AES3 I/O

RedNet D64R Rackmount, 64x64 MADI/Dante bridge

RedNet HD32R Rackmount, 32x32 Pro Tools HD/Dante bridge

RedNet HD32R is a multichannel, bi-directional Dante interface, which allows an Avid Pro Tools HD system direct access to a Dante digital audio networking system. Each unit acts as a 32in/32out, or 16in/16out at 192kHz digital break in/out box and supports a wide range of Pro Tools HDX and HD cards. Up to 6x RedNet HD32R modules can be used with a Pro Tools HDX system and 5x with Pro Tools HD, allowing the maximum channel count for either.

The rear facing panel features primary and secondary Ethernet connectors to allow maximum network reliability with switchover to a standby network if required. The network ports may also be used to daisy-chain additional units when operating in 'Switched' mode. Power supply in connections A and B offer redundant power with each input having the ability to be monitored remotely over the network or from the front panel. 2x standard DigiLink (Mini-DigiLink) connectors allow connection with a Pro Tools HD/HDX PCIe card via a standard Pro Tools I/O cable, with the expansion connector allowing the user to connect to a 2nd Pro Tools HD I/O interface when unit is operating in Expansion Mode. In this mode RedNet HD32R provides 16-channels of I/O instead of 32.

The front facing panel contains a set of LEDs to confirm network status, sample rate, clock sources and signal presence on both input and output. A main power on/off switch is positioned to the right side of the front facing panel, and independent LEDs signify PSU A/B application.

Supported sample rates: 44.1/48/88.2/96/176.4/192kHz at 24-bit. Pull-up/down: -4%, -0.1, +0.1, +4.167. Clock sources: Internal, Word Clock, Loop Sync (leader or follower), or Dante network leader. Word Clock connectors: 75ohm BNC. Included accessories: 2x IEC AC mains cables, 2x IEC mains cable retaining clips, 1x 2m Cat6 Ethernet cable.

Dimensions (HxWxD): 88 x 482.6 x 247.5mm. Weight: 3.9kg

RedNet MP8R Rackmount, Mic preamp

RedNet AM2 Desktop monitoring unit

RedNet X2P Desktop, 2x2 analogue/Dante

RedNet R1 Desktop remote

RedNet PCIeNX Dante interface card