With the greater than ever use of semi-pro and consumer interconnect products the importance of the humble adapter has increased significantly. Inevitably this leads to the odd hiccup in mating two products or cables together which is why Canford offers a wide range of audio and video adapters (or adaptors as our US cousins would say) that should solve a lot of problems. Canford also stock suitable cables and patch cords for these products.
This is a special HDMI female-female adapter that mounts into apertures punched for D-sub 9 pin connectors, enabling HDMI terminations in commonly available mounting plates and panels.
The Ikon HDMI-ST screw terminal adapter brings all the HDMI contacts out to screw terminals with minimal signal loss, and is designed for panel mounting applications.
A range of adapters to interface between HDMI and DVI digital video connectors. Designation denotes configuration of adapter contacts, all adapters supplied prewired. DVI connectors are 25 pin type, offering full digital connectivity.
| Stock Code |
Connector 1 |
Connector 2 |
Typical application |
| 48-607 |
HDMI Male |
DVI Female |
Enables DVI cable to be plugged into HDMI input |
| 48-608 |
HDMI Female |
DVI Male |
Enables HDMI cable to be plugged into DVI input |
| 48-609 |
HDMI Female |
DVI Female |
Connects HDMI cable to DVI cable |
| 48-610 |
HDMI Female |
HDMI Female |
For extending HDMI cable runs |
The Ikon DVI-ST screw terminal adapter brings all the DVI contacts out to screw terminals with minimal signal loss, and is designed for panel mounting applications.
HDMI RIGHT-ANGLE COUPLERS (48-605)
A useful HDMI female-female coupler, intended for situations where HDMI cable routings cannot avoid tight bends. As with most high data-rate cables, HDMI cables suffer degraded performance if their bend radius is too small. This coupler allows two individual cables to be joined end-to-end.
HDMI CABLE EXTENDERS (48-603)
This uses power from the HDMI bus to repeat the signal, therefore no external power supply is required. It allows cable runs to be extended up to 30 metres, according to cables used. It also can permit smaller gauge HDMI cables to be used, thus making installations easier in confined spaces. The housing has moulded lugs for screw fixing to joists etc. Meets 1080P DTV resolution. Use HDMI leads with a minimum of 0.08 sq.mm (28AWG) conductors for optimum length performance.
IKON USB SCREW TERMINAL ADAPTER (44-114)
The Ikon USB-ST screw terminal adapter brings the four USB contacts out to screw terminals with minimal signal loss, and is designed for panel mounting applications.
IKON D-SUB 90 DEGREE ADAPTERS (9 PIN & 15 PIN)
D-sub adapters that allow mating cables to lie flat in floor boxes, or pre-wired install cables to be used with “back-to-back” panel connectors when clearance is limited. Available in D-sub 9 pin and HD D-sub 15-pin formats.
A range of D-sub connectors mounted on housings which fit the Neutrik ‘D’ series cut-out. Suitable for use with Canford Universal Connection Panels, connector plates, stageboxes or any application where a Neutrik ‘D’ series cut-out is available. All configurations of D-sub 9 pin and HDD-sub 15 pin are available, in nickel finish shells. Black shells are available to special order, subject to minimum order quantities. In the ‘male-female’ types, the connector element is reversible.